1. krok 1
  3. root@kali:~# airmon-ng start wlan0
  4. Found 6 processes that could cause trouble.
  5. If airodump-ng, aireplay-ng or airtun-ng stops working after
  6. a short period of time, you may want to kill (some of) them!
  8. PID Name
  9. 541 NetworkManager
  10. 713 wpa_supplicant
  11. 718 dhclient
  12. 847 avahi-daemon
  13. 848 avahi-daemon
  14. 1501 dhclient
  16. PHY Interface Driver Chipset
  18. phy0 wlan0 ath9k_htc Atheros Communications, Inc. TP-Link TL-WN322G v3 / TL-WN422G v2 802.11g [Atheros AR9271]
  19. (mac80211 monitor mode vif enabled for [phy0]wlan0 on [phy0]wlan0mon)
  20. (mac80211 station mode vif disabled for [phy0]wlan0)
  22. krok 2
  24. airodump-ng -i wlan0mon
  25. ioctl(SIOCSIWMODE) failed: Device or resource busy
  27. ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
  28. ARPHRD_IEEE80211_FULL or ARPHRD_IEEE80211_PRISM instead. Make
  29. sure RFMON is enabled: run 'airmon-ng start wlan0mon <#>'
  30. Sysfs injection support was not found either.
  33. krok 3
  35. iwconfig
  36. eth0 no wireless extensions.
  38. lo no wireless extensions.
  40. wlan0monmon IEEE 802.11bgn ESSID:"lolo25"
  41. Mode:Managed Frequency:2.422 GHz Access Point: XX:XX:XX:XX:ZZ:ZZ
  42. Bit Rate=54 Mb/s Tx-Power=20 dBm
  43. Retry short limit:7 RTS thr:off Fragment thr:off
  44. Encryption key:off
  45. Power Management:off
  46. Link Quality=39/70 Signal level=-71 dBm
  47. Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
  48. Tx excessive retries:0 Invalid misc:29 Missed beacon:0
  50. root@kali:~# airodump-ng -i wlan0monmon
  51. ioctl(SIOCSIWMODE) failed: Device or resource busy
  53. ARP linktype is set to 1 (Ethernet) - expected ARPHRD_IEEE80211,
  54. ARPHRD_IEEE80211_FULL or ARPHRD_IEEE80211_PRISM instead. Make
  55. sure RFMON is enabled: run 'airmon-ng start wlan0monmon <#>'
  56. Sysfs injection support was not found either.